Note: Assignments for unsupported control surfaces always belong to the first control surface group.
Fader Bank for Current View: Maps to the fader bank for the currently used View allowing you to use one assignment per left or right button for all View modes.
Filter for All View: Choose to show eight additional checkboxes (for the eight channel strip types) when the View is All. Depending on the Value mode, these switches define which channel strips are displayed (by using Direct mode) or which are toggled (by using X-OR mode).
Fader Bank for: Channel strip choices are: MIDI, Input, Audio, Instrument, Aux, Bus, Output. These fader bank parameters are used in All View when only one channel strip type is displayed. This allows you to switch between several channel strip types, while retaining the current fader bank for each type.
If you choose one of the fader bank or parameter page settings from the Parameter pop-up menu, the following Bank Type options appear below the pop-up menu:
By One: The fader bank or parameter page is shifted by one channel strip or parameter.
By Bank: The fader bank or parameter page is shifted by the number of displayed channel strips or parameters.
CS Group Setting: The fader bank or parameter page is shifted by the value defined for the Parameter Page Shift Mode control surface group parameter.
Automation Group: Uses the assignment to set an automation group parameter. When chosen, a Group field appears below the Class pop-up menu. You can determine the edited group by entering a number in the field. Entering “0” sets this parameter to the group selected for the Automation Group parameter (in the control surface group parameters). A Parameter pop-up menu also appears below the Group field, allowing you to choose the automation group parameter for the assignment. For further information, see Overview of groups in Logic Pro.