Move the playhead to the point where you want to insert notes.
Choose Window > Show Step Input Keyboard.
Do one or more of the following:
To insert a note of the key’s pitch: Click a key.
To set the length of the inserted note: Click the Note Length buttons.
To set the velocity of the inserted note: Click the Velocity buttons.
There are eight velocity values—represented by the traditional volume indicators ppp, pp, p, mp, mf, f, ff, and fff. These correspond to MIDI velocity values 16, 32, 48, 64, 80, 96, 112, and 127, respectively.
To make the next three notes you enter a triplet group: Click the Triplet button.
The rhythmic value of the triplets is based on the currently selected note value.
To lengthen the selected note by half of the selected note value: Click the Dot button.
To lengthen the selected note by the selected note length value: Click the Sustain Inserted Notes button.
To correct the timing of the start of the next inserted note to the nearest bar or beat line: Click the Quantize button.
The position of the playhead is critical when you use this option.
To choose the MIDI channel of an inserted note: Open the Channel pop-up menu.
The channel settings of individual notes usually have no effect on the playback channel, and therefore the sound, of the MIDI region. The channel settings of individual notes are used mainly for polyphonic score display.
To insert multiple notes at different pitches at the same time: Click the Chord button.
The notes are “stacked” at the same position, resulting in a chord. The playhead doesn’t advance until the Chord button is clicked again (turned off). Chord mode prevents the playhead from moving after the insertion of a note, allowing you to insert as many notes as you like at the same bar position. Before you insert the last note into the chord, click the Chord button again to turn off Chord mode, and the playhead advances as usual after a note is inserted.
In Logic Pro, inserting notes with a MIDI keyboard is similar to using the Step Input keyboard. However, you press keys on your real-world MIDI keyboard, rather than clicking onscreen keyboard notes.
In Logic Pro, you can insert rests using step recording techniques.
If the Musical Typing window is displayed, press Tab without a key that represents a note.
Using the Step Input keyboard, make sure the previously created note is unselected in the Piano Roll Editor and click the Sustain inserted note(s) button.
Using your MIDI keyboard, without any keys being pressed, step on the sustain pedal.
Using the steps described in the Assign key commands in Logic Pro section, assign the Rest and/or Step Forward key commands to keys on your keyboard. Then press the key command to insert a rest.