While Editing Show Long Names For checkboxes: Turn on the two checkboxes in this section to determine how parameter names and values are displayed on the LCD of the control surface.
Parameter name checkbox: Turn on to show the full parameter name in the upper LCD line when you edit a parameter.
Parameter value checkbox: Turn on to show the full parameter value in the lower LCD line when you edit a parameter. If the Show value units for checkboxes (see below) are turned on, the value is appended by the unit type where applicable (for example, dB, Hz, or %).
Note: The following options only have an effect if at least one of the two parameters described above is active.
Display Duration slider: Set the time that parameter names and values remain on the LCD, following selection and adjustment.
Show info for multiple parameters checkbox: Turn on to show the long name and information in the LCD until the most recently edited parameter information display times out. This may cause overlapping text. Turn off to limit the long name display to show only the most recently edited parameter, which can cause screen flicker.
Show info when selecting tracks checkbox: Turn on to show “Selected” in the upper row of the LCD and the selected track name in the lower LCD row when you select a track.
Show info when editing volume checkbox: Turn on to show “Volume” in the upper row of the LCD and the edited value in the lower LCD row when you edit the volume of a track.
Show Value Units For checkboxes: Turn on to show the appropriate measurement unit (Hz or %, for example) after parameter values. You can set this option separately for instrument and effect plug-in parameters and track volume and other parameters. If you can work without value units, the display is less cluttered.
Note: This parameter applies only during edits to relevant values.
Controller Assignments button: Click to open the Controller Assignments window. See PDF
Logic Pro Effects: PDF